CHEM-CRETE PAVIX CCC100-5 5 GALLON PAIL

Description

Concrete water and moisture protection used for treatment and protection against water and moisture associated problems for all concrete and cementitious structures
Chem-Crete Pavix, is a patented dual crystalline penetrating concrete and masonry sealer that is 100% water based compound (H2o) containing only natural ingredients. Designed to protect these surfaces from the delaminating effects of water, moisture saturation, freeze/thaw, Alkali Silica Reaction (ASR), and chloride penetration. The protective properties are a distinctive surface repellent and moisture blocker, offering hygroscopic and hydrophilic capacities. Pavix is ideal for exterior or interior concrete and masonry surfaces and can be applied in both positive and negative side applications. Pavix will dramatically reduce maintenance costs and positively affect the life cycle of concrete and masonry products.
Uses:
Airports
Highways
Tunnels
Bridge structures
Ports authorities
Concrete structures
Parking surfaces & structures
Sidewalks & drives
Retaining walls
Precast/tilt concrete
Technical Data:
Specific Gravity
1.1 – 1.2
Viscosity
2.4 centipoises
Freezing Point
28ºF (-4°C)
Boiling Point
219ºF (104 °C)
Color
Clear
Environmental Hazards
None
Odor
None
Toxicity
None
Fumes
None
Flammability
None
Application:
Fully cured or existing concrete:
Repair and seal joints, cracks, and voids greater than 1/16th inch prior to application. Concrete surfaces must be clean and sound prior to application of the product. Proper cleaning will open the surface pores and capillaries to enhance the penetration process. Compressed air can be used to remove dust and loose particles from the surface. Flushing the area to be treated with water can improve the cleaning process. However, for heavily contaminated areas special concrete cleaning agents such as Chem-Crete CONCLEAN CCC060 can be used to remove dirt, grease, and oil from those areas.
Green/plastic application:
A test should always be performed for product absorption.
Only consider an application when concrete finishing is completed.
Concrete should not be in duress and should be curing normally.
Apply when all bleed water has dissipated from the
Apply Pavix uniformly and at the manufacturer’s recommended rate.
DO NOT allow the Pavix to puddle or pool. Should Pavix puddle or pool, remove this condition immediately by the best way possible. Additional movement of product with a broom, vacuum, or air blower is recommended.
Application of membrane forming curing compound should then immediately commence and not longer than 20 minutes from the initial Pavix application.
Apply the membrane curing compound at manufacturer’s recommended coverage rate.
Coverage:
Apply at an average coverage rate of 150-200 ft2/gal (3.7-4.9 m2/liter) in one coat. Do not attempt additional coatings.
Limitations:
Do not apply PAVIX in the following cases:
If temperature falls below 50°F (10°C).
If the area has been previously treated with sealing agents unless the sealers are removed by chemical or mechanical