2020 Brand New Tribostatic Portable Powder Coating System Paint Gun Coat Spray

Description

Tribostatic gun - YouTube
Video will open in a new window
[isdntekvideo]
Tribostatic powder coating gun
Specifications:
- This gun work with polyester and epoxy powder coat.
- Powder paint is a positive charge by rubbing on the PTFE parts of gun and is deposited on a grounded piece to be coated.
- Need only regular small compressor to 3 bar. 150 liter/min.
- No Faraday effect, deep crevices, corners and hollow spaces can be better penetrated
- Powder can be better directed by the use of directional finger sprayers and aerodynamics
- Less, if any, fat edges on the coated surface
-
No high voltage generator required
- Higher productivity by closer arrangement of objects
Only things required for use of this gun is air under pressure 0.1-0.25 MPa
No electricity, no sparks, no malfunctions or damages.
The big advantage of tribostatic guns is that they do not produce the Faraday cage effect, so coverage is consistent, even in recesses. The surface is also smoother and with much less orange peel effect than that obtained with Corona guns.
Tribostatic guns are especially suitable for difficult coating jobs where there are many recesses or empty spaces, and powder sprayed by corona guns would not penetrate without manual touch-up, or would mainly pass through the work without going onto the piece. Also, in extrusion coating, they give splendid results. Little manual touch-up is needed and the consumption of powder is on average 20% lower than with corona guns.
Tribostatic guns enable extrusions to be jigged very near to one another, consequently allowing high productivity without increased line speeds.
Powder spraying speed (m2/min)-
1.2
Compressed air pressure (mPa)-
0.1-0.25
Air consumption (m3/hour, not more than)-3
Weight (kg)-0.5
Dimensions(mm)-290*290*100
This tribostatic gun must use with an air compressor, connect it with 1.1cm diameter pipe or connector.
Gun cup-600ml.